Utility & Specialty Pumps

260
Model 260

1/6 hp Submersible Utility Pump


1/6 hp.
3/4" Discharge

Lightweight, portable and weighing only 7.5 lbs., the model 260 is perfect for miscellaneous water removal from pool covers, flooded areas or other clear water transfer applications.  Completely submersible and powered by a 1/6 hp motor, the 260 pumps down to as low as 1/8".  Garden hose connection.  Capabilities to 17 GPM, maximum head 25'.
331
Model 331

1/2 HP Portable Transfer Pump

 

1/2 HP 



Click for 360 Spin




This portable pump is perfect for boosting water pressure, draining hot water tanks and general water transfer.

Features include:

  • One-piece cast aluminum pump and motor housing with integral carry handle
  • Permanently lubricated bearings
  • A convenient On/Off switch
  • Powerful ½ HP motor capable of pumping to over 100 feet of head

    • Not intended for permanent installations.

     

     
    HT450
    HT450-Series

    1/2 hp High Temp Pump


    1/2 hp.
    1-1/2" Discharge
    3/8" Solids Handling


    Click for 360 Spin



    • 180 degrees Fahrenheit max fluid temperature
    • Oil-filled thermally protected motor
    • Permanently lubricated bearings
    • Powder coated finned aluminum motor housing
    • High temperature float
    • Stainless steel fasteners
    HT-40
    HT40-Series

    4/10 hp High Temp Pump


    4/10 hp.
    1-1/2" Discharge
    3/4" Solids Handling

      

    Click for 360 Spin

     

    Handling fluid temperatures of up to 200 degrees F., Liberty's HT40-series submersible pump is designed for hot water applications such as boiler blow-down pits, condensate pits and high temperature water transfer. Other features include all cast iron housings, epoxy powder coat finish and a high temperature float.

     
    ELV Series
    ELV-Series with OilTector

    Elevator Sump Pump System


    The ELV-Series sump pumps are designed and approved for safe operation of pumping, alarming and monitoring of elevator sump pits, transformer vaults and other applications where oil and water must be detected.  The OilTector® system will activate the pump to remove water from elevator pits in accordance with ASME A17.1, and will provide pumping of only water - even if an oil condition is detected.  The OilTector® cycles the pump only in the water range.  Oil and other harmful floating substances are not discharged into the environment.  An alarm is activated in the event of a high water condition or high oil condition.
    ELV Auto-Valve
    ELV Auto-Valve Simplex Series with OilTector

    Simplex Elevator Sump Pump System


    Simplex pump system detects oil and water - allowing for diversion of oil to a separate tank via automatic electronic valves. For use in elevator pits, vaults and other areas requiring the control of oil discharge from sump water.

     
    ELV Duplex
    ELV Duplex Series with OilTector

    Duplex Elevator Sump Pump System


    Duplex pump system detects oil and water allowing for diversion of oil to a separate tank via dedicated oil and water pumps. For use in elevator pits, vaults and other areas requiring the control of oil discharge from sump water.